Wednesday, October 03, 2018

Upgrading our Hardware

Amend “Running the Program” by doing the following:

  1. Change the text:
    https://jsfiddle.net/L6ebadys/1/
    to read:
    https://jsfiddle.net/L6ebadys/2/
  2. Change the text:
    into the “JavaScript + jQuery 3.3.1” section of the Hardware, with the cursor at line 1
    to read:
    in between the two lines beginning with “//” in the bottom-left section of the Hardware
  3. Remove the bullet point beginning:
    Press the “Run the Master Control Program” button

Amend “Master Control Program” by removing the line that contains the text:

var MCPOutput = “”;

The old Hardware is a bit obfuscated so I cleaned it up a little.

Comments

Kevan: he/him

03-10-2018 07:59:35 UTC

Much better. Although this wasn’t in the proposal category.